•  
  •  

Injection Molding

At Parker Precision Molding, injection molding of thermoplastics is what we do. With tonnages up to 400, we have the ability to run commodity resins, engineering resins, even flexible materials up to 48 ounces. Our machines utilize CNC controls; this allows us to "fine tune" our production setup to create the best possible part. Built in the controller software are information screens that tells the operator what the machine is doing, along with gives us a detailed history of each shot, thus creating tighter quality control of each part. Most of our machines are equipped with part and scrap handling robotics, this reduces handling by employees, thus keeping contamination of the part or scrap to a minimum, as well as allows us to keep production moving in our "light out" production.
image-placeholder.png

Machining

Beginning in 2016, Parker Precision Molding has started offering machining services. Our capabilities include manual turning and milling, as well as CNC milling and turning. Materials include steel, stainless, aluminum, titanium, bronze, brass, and plastics. More information coming soon.
image-placeholder.png

Quality Control

Our quality control department is stocked with the tools needed to inspect the products we make for our customers. Parts requirements are gone over with the customer upon beginning of the job. We discuss what dimensions are critical and non-critical, and what physical defects are allowed, if any. Then we create a quality control checklist containing the dimensional, physical and “spot checking” requirements. Closer tolerance parts get checked more often than parts that have a higher dimensional tolerance. These checks can be per part, per hour, per shift, etc. Every quality control check is done differently for each part. If any parts are to fail, we conduct checks to figure out if the issue is with the process, material, tooling, or mishandling and correct the issue. This helps keep our shipped parts reject rate to a minimum.
image-placeholder.png